6/29/2023 0 Comments Wood scaffold planksDouble Scaffold Planksĭouble scaffolding is mainly meant for stone masonry. All this is done to give maximum support to the weight of the workers. One end of each putlog is fixed to the wall and another to the ledger. The standards are placed 2 to 2.5 metres apart and the ledgers 1.2 to 1.5 metres apart. While at work, the plank is placed about 1.2 metres from the wall. It is made of structures such as the ledgers, standards and the putlogs. This type of scaffolding is used generally for brick masonry. Basically, there are many types of scaffold planks and they include the following: 1. These planks are either made of timber or steel and the type of plank you use will depend on the type of construction taking place. Scaffold planks are temporary structures used by constructors for support during building construction. LP® FlameBlock® Fire-Rated OSB Sheathing.Moistureshield Composite & Capped Decking.Billets are cut to size with rip-saws.ġ2. Heat and pressure are applied by the continuous press.ġ0.Samples are taken and tested through the Quality Control process.ġ1. LVL exits the press.is cut to desired length-called billets.ĩ. Veneer is stacked in a process that randomizes the effects of natural wood characteristics.Ĩ. Veneer enters the”lay-up”process based upon its strength characteristics to achieve the target LVL grade.ħ. Veneer is dried, visually graded and evaluated for strength then sortedĦ. Veneer is peeled in a continuous sheet and is clipped to size.ĥ. Logs are guided and centered into the lathe with lasers to optimize utilization. Logs are transported to the veneer mill.Ĥ. The whole production procedue is as below picture.ġ.Committed to maximizing the fiber sourced from sustainably harvested forests.Ģ. With our scaffolding board, you can be 100% sure that your workplace is 100% secure for the workers and free of hazards. We ensure top quality by performing several tests in the manufacturing process. So, you have to select LVL scaffold boards according to the material and workers working on the site.Īt APAC, we deliver immense effort to exceed the quality of LVL scaffolding planks beyond OSHA regulations. The deflection of scaffolding planks can not exceed 1/60th of its span supports.īuying LVL scaffolding plans following the OSHA standard is a good idea, but it doesn’t always provide the best support for the workers.Scaffold planking MUST NOT deflect more than one-sixteenth of its span between supports.Manufacturers should monitor, assess and improve the wood condition.Scaffold plank manufacturers must use scaffold-grade lumber.Here is the outline of OSHA, which should be applied to LVL scaffolding planks. Therefore OSHA released an extended regulations to ensure the scaffolding was well-built and sturdy. The organization stated that 45,00 workers get injured, which could be prevented with good quality scaffolding.įigure 3 – LVL scaffolding planks must meet OSHA standards In 2013, OSHA listed scaffolding as the third most violated item in the workplace. OSHA is a federal agency whose primary job is to ensure the safety of workers and offers long-term solutions for conventional workplace hazards.
0 Comments
Leave a Reply. |